The Ebara DWU Dominator sump pump is used in wastewater with suspended solids, commercial, industrial, containment transfer, irrigation and drainage applications.
The 3200 Series, 4" Reduced Diameter, submersible pumps are designed so that all parts of the pump end, including the cable guard, fall within the diameter of Franklin Electric’s industry leading submersible 4-inch motor. This reduced diameter pump end makes it ideal for installations where the well is considered encrusted or tight in comparison to a standard 4-inch well. The 3200 Series also offers a hydraulic stage design optimized for greater water and pressure output when installed at deeper well depths.
Franklin Electric's submersible FPS Series offers innovative design options, such as Tri-Seal, high capacity, environmental and boosting pumps ideal for a variety of applications. Combined with the availability you need, these pumps improve efficiency and minimize wear, even when handling abrasives.
Franklin Electric’s 6-Inch High Capacity Submersible Pump is ideal for farm, home, irrigation, industry, municipal and commercial applications, equipped with the power, performance, and reliability you expect from Franklin Electric.
Franklin Electric’s C1 Series Submersible Pump, Cistern Pump, is designed for use in gray water/filtered effluent service applications, the C1 Series cistern pump provides high performance and long life in less than ideal water conditions. The C1 Series pump is able to pass solids up to 1/8-inch without having a negative effect on the internal hydraulic components.
Franklin Electric's submersible FPS Series offers innovative design options, such as Tri-Seal, high capacity, environmental and boosting pumps ideal for a variety of applications. Combined with the availability you need, these pumps improve efficiency and minimize wear, even when handling abrasives.
The standard FPS 4400 4-inch submersible pump features the new TRI-SEAL floating stage system. This new stage system improves efficiency and protects against wear when pumping abrasives (sand).
The standard FPS Series V submersible pump features unique hydraulics that improve efficiency and minimize wear even when pumping abrasives. Discharge and motor brackets are available in thermoplastic or stainless steel with a removable check valve system. Available in 5, 7, 10, 15, 20, and 25 gpm, 1/2 - 5 horsepower.
IPT pumps by Gorman Rupp has a slim-design, lightweight CSA listed submersibles feature top discharge as well as cast-iron impellers, 304 stainless steel casing, motor housing, shaft and hardware.
The Grundfos Unilift AP and Unilift AP Basic are submersible drainage pumps designed for both temporary/portable installation and permanent free-standing installation.